In the General Settings section, fill in the following information:.Select Single Tunnel, and Click Continue.Select IPSec Site-2-Site Tunnel and select Continue.Go to the gateway in your network from which you want to create the tunnel to Check Point, select the three-dotted menu (.) beside it, and select Add Tunnel.Open your Management Platform and go to the Networks tab.Configuring the tunnel in the Management Platform Select External (leads out to the internet). Add Perimeter 81 gateway IP as IP Address.Select the Network defined by the interface IP and Net Mask. Add Perimeter 81 remote subnet 10.255.0.0 as IP Address.Under the General tab, fill in Name, IP Address, and Net Mask.Open the Perimeter 81 object you created.Create a Network group with All local networks to be trusted with the VPN tunnels.Īdding the Perimeter 81 gateway IP and remote subnet.Under Check Point firewall policy, add a rule for any to any, in and out to 10.255.0.0/16 (this may vary if you did not set the default subnet during Perimeter 81 network creation).Additional settings in Check Point Smart Console Important: The remote subnets you defined need to match exactly to the remote subnets entered within the Perimeter 81 side (if additional subnets are added, it can cause the tunnels to break from time to time).Set VPN Tunnel Sharing to One VPN tunnel per Gateway pair.Note that you'll need to set these exact preferences while configuring the tunnel at the Management Platform. Please note: Check Point recommends choosing a shared secret that contains at least 20 characters.ĥ. Add a Shared Secret and write it down as it will also be used in configuring the tunnel at the Management Platform.
Add your external Firewall IP as Satellite Gateways.Add your Perimeter 81 gateway as Center Gateway.Specify an Object Name of your own choice.Please make sure you have your gateway IP (which can be found in the Network tab in your Management Platform). Add Perimeter 81 Gateway as an object as shown in the image below.Configuring the tunnel at the Management Platform Creating a gateway object in the Check Point Smart Console.Adding the Perimeter 81 gateway IP and remote subnet.Additional settings at the Check Point Smart Console.Creating a gateway object at the Check Point Smart Console.The example values should be replaced with the actual values found within your Management Platform. This article describes how to configure Perimeter 81 on a Check Point firewall using the Checkpoint Smart Console.
0 kommentar(er)
